Results 1 to 2 of 2

Thread: Coping Beams (Beam-To-Beam)

  1. #1
    Member
    Join Date
    2011-09
    Posts
    2
    Login to Give a bone
    0

    Default Coping Beams (Beam-To-Beam)

    Hello Everyone,

    I am doing my first Revit project and it's not going as smooth as I was hoping

    I have a cantilevered beam that's picking up two beams. One of them can be coped nicely, but when I try to cope the second one, it doesn't give me the same result? I've attached two quick screenshots.

    Has anyone had a similar issue with this before? I don't know how to get rid of the small "leftover" from the coping?

    Thanks!
    Attached Images Attached Images

  2. #2
    Member
    Join Date
    2011-09
    Posts
    2
    Login to Give a bone
    0

    Default Re: Coping Beams (Beam-To-Beam)

    Found the issue. The beam that's cantilevering has to extend for the entire width of the beam flange of the beam that its picking up. It was only extending to the center of the other beam... This wasn't a huge issue, I just found it very annoying.

Similar Threads

  1. Legends - how to show beam-beam & beam-col conn?
    By lcamara in forum Revit Structure - General
    Replies: 2
    Last Post: 2014-05-04, 10:45 PM
  2. Beam Coping Tool ?
    By mbalsom in forum Revit Architecture - General
    Replies: 3
    Last Post: 2008-04-10, 02:42 PM
  3. Beams not showing in beam system
    By Eric Stewart in forum Revit Architecture - General
    Replies: 1
    Last Post: 2007-11-23, 03:17 PM
  4. Beam system - no beams at the ends
    By johk in forum Revit Structure - General
    Replies: 7
    Last Post: 2007-10-18, 06:31 PM
  5. Beam coping questions
    By bgarrett in forum Revit Structure - General
    Replies: 2
    Last Post: 2006-10-01, 05:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •