We ran into a mysterious problem where we are unable to snap to an intersection even though the two lines intersect....both are on the same Z plane. The only difference/oddity I've noticed is that when listed, one of the lines is noted with a current UCS & a 3D length for one of the lines:
LINE Layer: "A-FLOR-LEVL-N"
Space: Model space
Handle = 1f6ca6
from point, X=148'-6 5/16" Y=443'-8 1/4" Z= 0'-0"
to point, X=164'-8 1/16" Y=443'-8 1/4" Z= 0'-0"
Length =16'-1 3/4", Angle in XY Plane = 0.00
Delta X =16'-1 3/4", Delta Y = 0'-0", Delta Z = 0'-0"
LINE Layer: "A-FLOR-OVHD-N"
Space: Model space
Handle = 1c5075
from point, X=157'-1 9/16" Y=418'-11 1/16" Z= 0'-0"
to point, X=157'-1 9/16" Y=460'-2 1/16" Z= 0'-0"
In Current UCS, Length = 41'-3", Angle in XY Plane = 90.00
3D Length = 41'-3", Angle from XY Plane = 0.00
Delta X = 0'-0", Delta Y = 41'-3", Delta Z = 0'-0"
Our intention is to continue in 2d and I can't seem to find a command that works. I tried flatten, but that's not a command in 2012 (and I think that works for meshes & arcs).
Please HELP! Thanks!