Hi all,
I'm working on a renovation of a mechanical room, I have chillers and pumps I'm removing and replacing. I'm having two issues that stand out:
1. When I change phase demolished to existing for selected equipment/pipe/ducts I receive an error saying "Elements need to be disconnected. When I click "Disconnect" every fitting/transition for duct and piping disconnect from each other and I see tons of the little explanation point deltas. When I tab the selected equipment/pipe/duct it only selects the highlighted one, the components truly are disconnected.
2. When trying to connect to existing pipe/duct the new construction pipe/duct wants to take the extent of new construction back to the next fitting. That works for a few areas but is not practical on many more. I have been using the "Split Element" tool to decide the extent of the demo pipe/duct, a coupling appears in the pipe and upon trying to reconnect to it with new construction it does not connect. I have also tried to put the coupling in as new construction but I have issues trying to reconnect as well.
I have tried to search for solutions and haven’t found much on it. Any help or suggestions would be great!
Thanks,
Ron