I know there are some work arounds out there for this but is there any good way to get the beginning and ending station to show up with a decimal point and not all the major stations? Think more along of the old LDD look.
I know that there are some tricks with adjusting the increment and adding more minor stations. But I don't want to have to rely on each person to have to do that when they create an alignment. I would like it to be set up in the Label Sets so I can just pick and go.
It would also be nice not to have C3D label the beginning and end stations twice like it does if you use major stations and geometry points with beginning and end geometry points selected.
Maybe I am looking for too much and have to rethink the way we want to label our alignments moving away from the good old LDD look.