Hope some one could kindly offer me some help, attached is a common cuboid,
I made a void cone with the vertex along one of the edge of the cuboid aimed to cut the cuboid.
but the problem is, if the vertex angle is very sharp, it will inform me that Revit Can't keep elements joined.
then I can't cut.
but if I sslightly move away the cone from the edge, everything works fine.even inside the cuboid.
and If the vertex angle is larger or say with lower slope, it also works.
20120201 19 5.png is the offset one ,
20120201 20 11.png is the one with larger vertex angle,
these two both works well
20120201 20 9.png is the one with very sharp vertex angle I have problem with
bug1Family1.rfa is model which I have problem with.