how to show center line of ducts in hidden view in revit mep 2011.

[swapr78]

Hi all,

how to show center line of ducts in hidden view in revit mep 2011.

[smcmillin]

In Visibility Graphics set your duct & duct fittings to transparent. I'm not a mechanical guy so I don't know what negative affects this would have on the overall design intent.

[gegetf353842]

Hi all,
that's a nice workaround, but then you have a conflict where two ducts on different level cross each other on a plan view. A round duct will be visible under the other round duct (since it's transparent), overriding the "hidden line" principle designated to this view style...