I'm trying to utilize ramps in my below grade parking, but there are a few issues with them. I've done some searching on this, but all the comments come from 4-5 years ago so I was hoping they had been resolved by now, but I'm not figuring it out.
1. Walls/columns can't attach to a bottom of a ramp (however they will to a sloped floor)
2. Ramps will not join with slabs even with a constant material (in this case, concrete) This means linework tool is the only way to make it look right in sections.
3. Can't place a spot elevation along a ramp at any point, even a defined edge. I need to place a reference plane and then put a spot elevation on that plane.
Is using sloped floors the way to go? What's the point of ramps then? Any solutions? (i'm half frustrated, half curious)
Thanks