I am using Revit 2012 and i have run into an issue regarding Duct lining. When i have part plans, i typically go through and hide elements within the part plan. However if i have ductwork that is lined within the part plan the duct will hide but the lining will not. As a result i have bits and pieces of ductwork within the part plan which causes the drawing to look incomplete and incorrect.
I considered using a masking region to block all the ductwork within specific rooms but this does not work when i cross walls.The same effect occurs with insulation as well. I've considered turning it on/off for prints but this will be very tedious as acoustical lining is required almost everywhere in this particular project.
I can use break lines but this will only hide a small portion of the ductwork or atleast the straight runs entering the part plan.
Anyone have any ideas?
Thanks.