Results 1 to 2 of 2

Thread: Can duct auto-routing be turned off?

  1. 2012-04-19, 11:45 AM #1
    JColombe406013
    JColombe406013 is offline
    Member
    Join Date
    2012-03
    Posts
    18

    Default Can duct auto-routing be turned off?

    Is there a way to turn off auto route for ductwork
    Reply With Quote Reply With Quote
  2. 2012-04-23, 02:34 PM #2
    dennis howell
    dennis howell is offline
    100 Club dennis howell's Avatar
    Join Date
    2007-01
    Location
    Suwanee, just north of Atlanta
    Posts
    160

    Default Re: Can duct auto-routing be turned off?

    You can toggle off "AutoConnect" during the DUCT command, and then it should 'remember' that you have it off.
    No matter how much you adjust your View Range,
    if you have to wear glasses, you will still need to wear glasses.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Duct/Pipe Auto Sizing
    By ryan.e.harold in forum Revit MEP - General
    Replies: 4
    Last Post: 2010-11-18, 10:48 PM
  2. Can you build this duct auto?
    By sjsl in forum Revit MEP - General
    Replies: 3
    Last Post: 2008-12-18, 05:12 AM
  3. ROUTING PREFERENCE DEFINITION
    By sam_ctlim in forum AMEP General
    Replies: 0
    Last Post: 2008-08-06, 10:01 AM
  4. Round Duct Routing Question
    By kyle.bernhardt in forum Revit MEP - General
    Replies: 2
    Last Post: 2007-06-12, 03:38 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules