Wall and window - I don't want it cut

[CADMama]

I have a curtain wall with a middle metal panel hiding a column. I want the furring wall to go meet with the mullion.
Is this even possible?

[cliff collins]

A bit clunky, but--
Use "disallow join" on the blue dot at the end of the furring wall. Then edit profile so it "steps" in and aligns with the mullion. (can't tell if the glass is floor to ceiling, or if there is a sill/wall below?)

[CADMama]

Didn't think about that - it works. I guess I just thought about the "joining" with walls and not windows.