Transformer Secondaries

[Sparky]

I have a transformer that feeds three different panels. The standard transformers allow for one secondary connection. I went to edit the family but I only see the primary connector. How do I edit this to make three secondary connections?

I figured it would be simple like a quad with two circuits. All you do is add a connector.

I just don't see this for a transformer.

Thanks in advance.

[Steve_Stafford]

You should be able to increase the "Max #1 Pole Breakers" parameter to allow for more "circuits" in the transformer, probably set to 3 now for a 3 phase panel connection. For two more panels you'd need to make it 9. See if that gives you the result you're after.