Search the Community

Ask, Learn and Solve

The AUGI forums are an online community where AUGI members
can discuss what they use everyday,
Autodesk Design Software!

See the top rated post in this thread. Click here

Results 1 to 2 of 2
  • Thread Tools
  • Display
  1. #1
    Active Member
    Join Date
    2008-07
    Posts
    55


    Default Raised floor construction (and what might be called laziness)

    Hello again all.

    I'm working on a project using raised floors (150mm above a 200mm deep structural slab). Floors, curtainwall, etc are based upon a conceptual mass.

    I was lazy/working quickly at first and defined the ENTIRE floor (concrete, void, finish) in one assembly.
    01_assembly.JPG

    My hope, when cutting sections, was for the floor to be 'smart' enough to show the assembly as above. Instead the whole assembly appears as concrete.
    02_section.JPG

    Is it possible to define this better within one assembly... or is the 'best' practice to go back and re-define the raised floor as a separate floor (and on a different workset)?

    Thanks.

    JP-

    And, for reference, this was probably the closest post I found: http://forums.augi.com/showthread.ph...floor-finishes

  2. #2
    Active Member
    Join Date
    2008-07
    Posts
    55


    1 members found this post helpful.

    Default Re: Raised floor construction (and what might be called laziness)

    Oh, never-mind.

    My detail level was simply far too coarse (duh).

    But I should still consider splitting out to individual worksets.

    (Gotta make stupid mistakes sometimes)
    JP-

  • Thread Tools

Similar Threads

  1. hatching construction elements under the floor
    By jkk007 in forum Revit Structure - Wish List
    Replies: 2
    Last Post: 2007-11-06, 08:02 AM
  2. Raised Paneling Wainscoting
    By Anthony.d in forum Revit Architecture - General
    Replies: 3
    Last Post: 2007-05-25, 12:10 PM
  3. Architectural - Raised Panel Block
    By Father-of-Ten in forum Dynamic Blocks - Sharing
    Replies: 0
    Last Post: 2007-02-02, 04:59 PM
  4. raised paneling
    By tect75 in forum Revit Architecture - General
    Replies: 3
    Last Post: 2005-10-14, 04:17 PM
  5. Cabinets with Raised Panel Doors
    By doug.61606 in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2004-09-16, 02:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •