See the top rated post in this thread. Click here

Results 1 to 2 of 2

Thread: Raised floor construction (and what might be called laziness)

  1. #1
    Active Member
    Join Date
    2008-07
    Posts
    55
    Login to Give a bone
    0

    Default Raised floor construction (and what might be called laziness)

    Hello again all.

    I'm working on a project using raised floors (150mm above a 200mm deep structural slab). Floors, curtainwall, etc are based upon a conceptual mass.

    I was lazy/working quickly at first and defined the ENTIRE floor (concrete, void, finish) in one assembly.
    01_assembly.JPG

    My hope, when cutting sections, was for the floor to be 'smart' enough to show the assembly as above. Instead the whole assembly appears as concrete.
    02_section.JPG

    Is it possible to define this better within one assembly... or is the 'best' practice to go back and re-define the raised floor as a separate floor (and on a different workset)?

    Thanks.

    JP-

    And, for reference, this was probably the closest post I found: http://forums.augi.com/showthread.ph...floor-finishes

  2. #2
    Active Member
    Join Date
    2008-07
    Posts
    55
    Login to Give a bone
    1

    Default Re: Raised floor construction (and what might be called laziness)

    Oh, never-mind.

    My detail level was simply far too coarse (duh).

    But I should still consider splitting out to individual worksets.

    (Gotta make stupid mistakes sometimes)
    JP-

Similar Threads

  1. hatching construction elements under the floor
    By jkk007 in forum Revit Structure - Wish List
    Replies: 2
    Last Post: 2007-11-06, 08:02 AM
  2. Raised Paneling Wainscoting
    By Anthony.d in forum Revit Architecture - General
    Replies: 3
    Last Post: 2007-05-25, 12:10 PM
  3. Architectural - Raised Panel Block
    By Father-of-Ten in forum Dynamic Blocks - Sharing
    Replies: 0
    Last Post: 2007-02-02, 04:59 PM
  4. raised paneling
    By tect75 in forum Revit Architecture - General
    Replies: 3
    Last Post: 2005-10-14, 04:17 PM
  5. Cabinets with Raised Panel Doors
    By doug.61606 in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2004-09-16, 02:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •