Results 1 to 4 of 4

Thread: Corridor Intersection Curb Return Problems

  1. #1
    Member
    Join Date
    2008-01
    Location
    Prescott, Az
    Posts
    5
    0 Did you find this post helpful? Yes

    Question Corridor Intersection Curb Return Problems

    I can create an intersection with the intersection wizard but I can't figure out how to edit the curb profile parameters. When I change the length to extend the curb return profile alignment (it is set to "yes) it will not accept my entry. I want to extend the curb return alignment about 75 feet up past the return (it was created with a 25 foot extension) and warp the curve and the edge of the road it is intersecting into, but the the intersection modify buttons will not let me change the length of the alignment or the profile. Any thoughts would be appreciated. I will do it manually until I figure this out.

  2. #2
    AUGI Addict
    Join Date
    2001-10
    Location
    Arizona
    Posts
    2,337
    0 Did you find this post helpful? Yes

    Default Re: Corridor Intersection Curb Return Problems

    did you use DESIGN data or allow the application to create DYNAMIC alignment/profile data for you?

    IF Design data was used it will not (or can not) do what you are asking it to do.
    Be your Best,


    Michael Farrell


    www.primeservicesglobal.com

  3. #3
    Member
    Join Date
    2008-01
    Location
    Prescott, Az
    Posts
    5
    0 Did you find this post helpful? Yes

    Default Re: Corridor Intersection Curb Return Problems

    I used alignments, cl profiles and assemblies. I don't know what alignment/profile data is...

  4. #4
    AUGI Addict
    Join Date
    2001-10
    Location
    Arizona
    Posts
    2,337
    0 Did you find this post helpful? Yes

    Default Re: Corridor Intersection Curb Return Problems

    Dynamic alignments and profiles...there is a prompt at the end of the process
    which did you chooes Design Data
    or Dynamic alignments and profiles?
    Be your Best,


    Michael Farrell


    www.primeservicesglobal.com

Similar Threads

  1. Intersection Wizard--Curb Return
    By raunelortiz659677 in forum AutoCAD Civil 3D - Corridors
    Replies: 11
    Last Post: 2012-02-10, 04:25 AM
  2. Problems with OSNAP: Intersection ACAD 2012
    By Jen-AWI in forum AutoCAD General
    Replies: 2
    Last Post: 2011-10-14, 09:34 AM
  3. Intersection Assembly Set - Target Problems
    By kevin.jackman in forum AutoCAD Civil 3D - Corridors
    Replies: 1
    Last Post: 2010-05-06, 03:19 AM
  4. Corridor Problems
    By alien_frik in forum AutoCAD Civil 3D - Surfaces
    Replies: 5
    Last Post: 2009-06-04, 06:26 AM
  5. Getting the curb in my corridor to tie into existing
    By kvandyke in forum AutoCAD Civil 3D - Corridors
    Replies: 3
    Last Post: 2009-02-09, 01:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •