Results 1 to 1 of 1

Thread: Automating dataextraction so extracted data refer to the current drawing only

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2012-05
    Posts
    1
    0 Did you find this post helpful? Yes

    Default Automating dataextraction template so extracted data refer to the current drawing always

    Hello!

    I'm trying to automate the dataextraction process. I have created a .dxe template file using a drawing. I saved the dxe template to a readable folder so I can use it by name. I've created a palette tool with the macro: ^C^C-dataextraction;template.dxe;

    The problem is when I use the tool with any other drawing than the one that created the template, I keep getting the same table inserted. How can I make the extraction to automatically read data from the current file I use the palette tool in?
    Last edited by zio78416850; 2012-05-02 at 02:27 PM.

Similar Threads

  1. Automating Label & Callout Data
    By monzoor.hossain780589 in forum CAD Management - General
    Replies: 4
    Last Post: 2011-10-24, 08:43 PM
  2. Replies: 0
    Last Post: 2011-10-24, 03:30 PM
  3. Automating Drawing Standards via Tool Palettes
    By TerribleTim in forum AutoCAD Customization
    Replies: 15
    Last Post: 2007-05-17, 03:56 PM
  4. Does a drawing refer to an XREF
    By acadwishlist in forum AutoCAD Wish List
    Replies: 5
    Last Post: 2006-11-01, 08:05 PM
  5. Notes that refer to drawing number on sheet
    By Archman in forum Revit Architecture - General
    Replies: 5
    Last Post: 2005-07-30, 12:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •