Results 1 to 1 of 1

Thread: My adaptive component won't attach to parallel surfaces

  1. #1
    I could stop if I wanted to scowsert's Avatar
    Join Date
    2006-08
    Location
    Olympia, WA
    Posts
    415
    0 Did you find this post helpful? Yes

    Default My adaptive component won't attach to parallel surfaces

    I've got this pipe that I'd like to connect between two floors. It'll attach just fine if the two surfaces aren't parallel. Any adaptive folks out there that can take a look at it for me? I've attached a 2012 Revit file with the family in it. Basically if you can get it to attach between the two floors in the rvt file that would be awesome. I'm assuming the family needs tweaked some how.

    Thanks in advanced.
    Sage
    Attached Files Attached Files

Similar Threads

  1. Bisecting Plane Adaptive Component
    By brenehan in forum Revit - Conceptual Design Tools
    Replies: 1
    Last Post: 2011-04-05, 04:46 PM
  2. Adaptive Component Tree Column.
    By craighowie in forum Revit - Conceptual Design Tools
    Replies: 9
    Last Post: 2010-10-18, 02:09 AM
  3. UV grid by intersection + Adaptive component
    By pfaudler in forum Revit - Conceptual Design Tools
    Replies: 0
    Last Post: 2010-10-12, 01:40 PM
  4. Multi Spline Sweep - Adaptive Component
    By brenehan in forum Revit - Conceptual Design Tools
    Replies: 1
    Last Post: 2010-09-09, 02:10 AM
  5. Adaptive Component VS Mass
    By craighowie in forum Revit Architecture - General
    Replies: 2
    Last Post: 2010-07-14, 08:18 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •