Results 1 to 2 of 2

Thread: Double Coding Line work

  1. 2012-05-10, 12:46 PM #1
    Jdraper276160
    Jdraper276160 is offline
    Member
    Join Date
    2012-02
    Posts
    3

    Default Double Coding Line work

    I am trying to double code line work. I brought in a .csv file and I had a few double codes that did not connect. My code was EOG2 ST ENT, for Edge of Gravel, also starting an entrance. The line work will not connect from my previous Edge of Gravel shot to this one. Any reason why?
    Reply With Quote Reply With Quote
  2. 2012-05-16, 04:04 AM #2
    mjfarrell
    mjfarrell is offline
    AUGI Addict
    Join Date
    2001-10
    Location
    Arizona
    Posts
    2,337

    Default Re: Double Coding Line work

    do you have auto start on figure prefix matching enabled?
    have you tried adding a B code after the ENT?
    Be your Best,


    Michael Farrell


    www.primeservicesglobal.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. MEP 2011 - Problem with Hidden line view in double line piping
    By cdonahue278905 in forum Revit MEP - General
    Replies: 2
    Last Post: 2011-04-01, 06:18 AM
  2. Pipe Single line and double Line
    By Gindelicato in forum Revit MEP - General
    Replies: 3
    Last Post: 2009-10-17, 02:06 AM
  3. Line Coding and In-Roads
    By markj.193961 in forum Survey - General
    Replies: 1
    Last Post: 2009-03-17, 07:21 PM
  4. Specify double-line or single-line ductwork?
    By seventwo in forum AMEP General
    Replies: 12
    Last Post: 2008-12-18, 07:27 PM
  5. Set up a Hyperlink in a DWG to work with a double-click
    By clive.shipping in forum AutoCAD General
    Replies: 2
    Last Post: 2006-11-22, 03:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules