2013 - Still no collate!

[patricks]

Collated printing still does not work in 2013. Seriously, I mean it's already beyond ridiculous. 13 releases now since 6.1 (if you count the old point releases) and not one time ever have we had a working Collate function.

They told me in 2010 that it would be fixed in 2011, and again fixed in 2012. In 2012 they said it was still open with development. Is this like the worst, most difficult problem that's ever been encountered in the history of programming??

[david_peterson]

They also said it was a seamless transition from Revit to Cad and Cad imported into Revit.
But I'm still hoping for a text editor. At least I can take a program like pdf-exchange and combine pdf's after so at least there's a work around.

[arb]

Yea, we just batch plot "chunks" of sheets that collate properly and then combine them with Acrobat afterwards. Some of our floor plans don't sort properly because the print order (from what I can tell) is alphabetical, so our sub-basement plans (A1-0SB) sort after the Basement (A1-0B) and Ground floor plans (A1-0G).

[david_peterson]

Yea, we just batch plot "chunks" of sheets that collate properly and then combine them with Acrobat afterwards. Some of our floor plans don't sort properly because the print order (from what I can tell) is alphabetical, so our sub-basement plans (A1-0SB) sort after the Basement (A1-0B) and Ground floor plans (A1-0G).

I guess I'm just lucky then. My sheet always stack in the right order anyway. I guess the NCS was good for something.