Flipping Dimension tick marks...

[DGRevitModeler]

Does anyone know if there is a way to get the dimension tick marks (in my case arrowheads) to flip to the outside of a dimension?

I have attached a screen shot of what I am talking about.

I have looked just about everywhere I know to find a setting for this but I came up with nothing. Is this just a setting thats programmed into Revit?


Anyone have any thoughts?


Thank you Very Much,

D

[Dimitri Harvalias]

Welcome to the forums.
As far as I know you are out of luck. Revit has a pre-defined list of typical arrowheads and all you can do is create a smaller arrow head for instances like these. No way to flip them though.