Unable to execute tool ...

[KBAArchitects]

I have just updated to ACA 2013 - My tool palettes are dysfunctional at best. I have two seats - on one I get the message "Unable to execute tool. Class not registered" and on the other I get "Unable to execute tool. Not enough storage is available to complete this operation" I have done everything I could find in the forums at Autodesk Subscription - inlcuding 'repair' and 'reinstall.' I am very very frustrated - my work output has slowed to a crawl.

[milo363577]

I have just updated to ACA 2013 - My tool palettes are dysfunctional at best. I have two seats - on one I get the message "Unable to execute tool. Class not registered" and on the other I get "Unable to execute tool. Not enough storage is available to complete this operation" I have done everything I could find in the forums at Autodesk Subscription - inlcuding 'repair' and 'reinstall.' I am very very frustrated - my work output has slowed to a crawl.

I am experiencing this as well. I have run several repair installations. At times I get a "not registered" message, other times I can open the tool palettes but none of the selections are draggable - all have the red x. Did you ever get a solution?