Results 1 to 2 of 2

Thread: Creating Pitched roof

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2012-11
    Posts
    1
    0 Did you find this post helpful? Yes

    Default Creating Pitched roof

    Hi,
    I'm new to Revit and I am trying to model a pitched roof which has three different clear span widths, that is on plan, the exterior walls look like a set of steps.
    I have drawn the roof using the footprint command, but the ridge line is also stepped, and I am looking to have a continuous ridge line. I have also tried the extrusion command but with the result of one continuous roof with no change in width. Would anyone have any ideas.

  2. #2
    All AUGI, all the time gbrowne's Avatar
    Join Date
    2004-03
    Location
    Glasgow, Scotland
    Posts
    574
    0 Did you find this post helpful? Yes

    Default Re: Creating Pitched roof

    Welcome to the forum!

    Roof edit.jpgstepped roof.jpg

    Is it like this? Just make one of the lines the 'defines slope' one, that should do it.

    GB

Similar Threads

  1. multi pitched roof
    By t1.shep in forum Revit Architecture - General
    Replies: 10
    Last Post: 2009-11-09, 07:32 AM
  2. Creating a Real Roof?
    By Tyveka in forum Revit Architecture - General
    Replies: 2
    Last Post: 2007-05-04, 02:17 AM
  3. Pitched Steel Roof Truss
    By Steve Jager in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2006-08-31, 01:57 PM
  4. demolishing part of pitched roof
    By dmw in forum Revit Architecture - General
    Replies: 5
    Last Post: 2006-01-12, 07:20 AM
  5. Creating a roof between points
    By rgranja508683 in forum Revit Architecture - General
    Replies: 5
    Last Post: 2005-07-02, 09:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •