Table cell won't keep alignment

[Noto81]

I've got a Sheet List Table on my title page for a set of drawings. For whatever reason There's a few cells that decide to do their own alignment, regardless if the cell is locked or not. Anyone else run into this? It has happened to a radom cell in the middle of a column or it can be an entire column. And its not just this drawing set, most of the drawing sets that i work with have at least one rogue cell.

The table is created based off a SSM, fwiw.

[Wanderer]

I've got a Sheet List Table on my title page for a set of drawings. For whatever reason There's a few cells that decide to do their own alignment, regardless if the cell is locked or not. Anyone else run into this? It has happened to a radom cell in the middle of a column or it can be an entire column. And its not just this drawing set, most of the drawing sets that i work with have at least one rogue cell.

The table is created based off a SSM, fwiw.

I have not had that occur.

Is there any way you can upload a dwg (and a dst, if necessary) that contains a table exhibiting this behavior so we can poke at it?

[Noto81]

I have not had that occur.

Is there any way you can upload a dwg (and a dst, if necessary) that contains a table exhibiting this behavior so we can poke at it?

I don't think the dwg will keep the Sheet Set Manager Link to the pages, therefore the table would have no information in it.

Not only that, but I don't think my employer would like that.

[Wanderer]

I don't think the dwg will keep the Sheet Set Manager Link to the pages, therefore the table would have no information in it.

Not only that, but I don't think my employer would like that.

Well, I assume a working drawing would be too big to upload anyway. But, a simple mockup with no real content in it could get the point across.