Results 1 to 2 of 2

Thread: Duct branch connection results in single line duct!

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2015-09
    Posts
    1
    Login to Give a bone
    0

    Default Duct branch connection results in single line duct!

    Revit 2013 with latest service pack installed and i am relatively new to Revit.

    when i extend a branch duct to connect to a main duct the result is the main duct is shown single line (see attached images). have looked all over for settings and have tried different options for sizes but always with the same results. both duct and branch are the same elevation. can anyone help?
    Attached Images Attached Images

  2. #2
    I could stop if I wanted to
    Join Date
    2016-01
    Location
    I come from a land downunder...
    Posts
    230
    Login to Give a bone
    0

    Default Re: Duct branch connection results in single line duct!

    Try this:
    1. Delete the main duct (from the radius bend)
    2. Copy either one of the two branch ducts to a spot nearby, then rotate the new duct through 90 degrees, move it to roughly where the previously deleted main duct was and then resize this new duct to the main size.
    3. Now try dragging the two branches onto the main duct and see if it works.

    If it does work, it still doesn't explain why the problem is occurring, but it goes a little way to isolating the problem, I guess!
    Good luck....

Similar Threads

  1. Single Line Duct Taps
    By ltuss in forum Revit MEP - Families
    Replies: 3
    Last Post: 2010-05-18, 05:19 AM
  2. How Do Make A Duct or Pipe show in Single Line
    By r_pungitore in forum Revit MEP - General
    Replies: 3
    Last Post: 2010-03-29, 03:56 PM
  3. How do you connect a branch duct FROM THE BOTTOM of the main duct?
    By oshalygin in forum Revit MEP - General
    Replies: 9
    Last Post: 2008-11-10, 09:08 PM
  4. Single and Double line pipe/duct in same view
    By dmb.100468 in forum Revit MEP - Wish List
    Replies: 5
    Last Post: 2008-08-21, 11:32 PM
  5. Single Line Duct Taps
    By mjdanowski in forum Revit MEP - General
    Replies: 4
    Last Post: 2007-09-24, 04:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •