Hi everyone, my question has to do with vertical reveals used as chamfers (basically vertical reveals that are always at the edge of the wall) for Precast Walls. Basically what I need revit to do here is allow me to apply a vertical reveal to the (left/right) edges of walls like it does to the top/bottom edges in the walls system family. I am currently just aligning the edge of the reveal to the edge of the wall so it moves with it, but inevitably the lock will get broken when (for instance) I need to adjust the profile of said wall, the association gets lost just by going into edit mode. If I'm missing something obvious, then I would appreciate any info I can get on the subject of vertical reveals. Thank you.