Originally Posted by
vladimir.karatsupa982899
Thank you for correcting me...
In my case the block that I would like to insert is not in just one file directory it is attached to every job folder.
What am I doing wrong in the following routine
(command "insert")
Enter block name or [?] J:\\123\\4567\\00\\Prod\\Xref\\Datum_Grid\\1234567_DATUM.dwg
Invalid block name
I tried entering "?" and then pasting the address...but no luck
Are you doing this on the command line or in a lisp?
Is the block named "1234567_DATUM"?
Try on the command line: (note the single slashes, no "dwg" suffix)
Code:
-insert
J:\123\4567\00\Prod\Xref\Datum_Grid\1234567_DATUM
Or in a lisp:
Code:
(command "-insert" "J:\\123\\4567\\00\\Prod\\Xref\\Datum_Grid\\1234567_DATUM" ...