Hello all, new to MEP. I used to work with Mechanical a few years ago.

I am modeling some heating supply/return pipes.

I got to a point where I need a 1-1/2" full port soldered bv. The one that I pull out of the tool palette is too small. It's measuring 1" outside diameter. It also won't allow 1-1/2" pipe to snap to it.

The 2" full port soldered bv I used on the other end of the run fit perfectly and measured correctly.

I don't see an option to modify the valve (mvpart) like I have the option with various fittings.

Any insight?

Thanks