We have a job that will have load bearing stud walls, cold form joists and a framed floor. There will also be at the top of the walls a boxed system (We will call this a beam) that the slab will pour down into the same depth as the bottom of the joists.
My question is we would like to have the "beam" as part of the wall system, so that it pops in at the top of the wall, is this possible?
Also we would like to make the slab system to incorporate the whole floor, (the slab, deck and the joist - but we only want it to show a line for the joist. These joists will not be modeled into our building. Is there a way to do this?
Will Revit allow the wall with the so called "beam" at the top to go thru the slab?
I included a picture of the section so you know what I am talking about.