Hello,
I got some problem with the stair. I placed a stair in the model. The modelled building consists of 3 floors (ground-, 1st & 2nd floor). The defined basic steel stair has 20 treads (from ground floor up to 1st floor). The floor height of 1st and 2nd arn't same. 1st is 3900+ and 2nd is 3550+ (see attached pict. elevation.jpg).
Questions:
1. If I select the function "multistory top level" to 2nd floor, I got the warning that revit doesn't make/copy the stair to 2nd level, because the last threads of the stair end at another level. And I don't see then the stair to 2nd floor . How can I fix that?
2. If I select the "mutistory top level" to top of the roof, revit can do it (surprising). of course you can see that the landing of the stair will not be placed at the 2nd floorlevel. But now I see that the connection between the landing and the stair doesn't run smoothly (see 3D.jpg and elevation.jpg). How can I fix that?
elevation.jpg 3D.jpg