Dear all
I am having some problems running the heating and cooling load calculations in Revit 2013.
The results are varying wildly so much that they are obviously incorrect.
The project I am working on is a condominium project in Bangkok and I have 2 identical units albeit mirrored and on the opposite side of the building width ways and one unit is showing that the design cooling load on one is almost 4 times higher than the other even though the materials and window areas are identical.
These units are only 9 metres apart!
This is the first time I've really tried te calculations seriously and either I'm making a glaring mistake in setting the analysis up or Revit is not reliable for this.
Any help or suggestions would be much appreciated.
Best regards
Peter D