Originally Posted by
gra77
Hi All
I have posted this question before, but I am still pulling my hair out to find an answer, I have hust bought the new MEP 2014 book, but as usual, if it is not Mechanical, forget it!
I have been trying to do some Panel Schedules and three phase circuits in revit
On this job I need to tag the circuits a bit differently, ie show them in the three phase 1L2, 2L2….etc for lighting as these go on a dedicated lighting board and 1P1, 2P2….etc for power as these go on a dedicated power board.
Circuiting them is not a problem as I can create a Circuit Number Parameter and assign a value to it, but my problem is then when we push this information over to the Panel schedules, it will only show the Circuits as 1,2 and 3 etc...(the column down the left most side under CKT)
I have tried to manipulate this, but even though I feel like I am close, I am still not getting it!!
Has anyone done this before, if so, any tips tricks??
It obviously is controlled by the DB settings and the panel schedule template, but any starters??
Thanks