Not sure if this is possible but...I am using a ceiling occupancy sensor and I want two circles that emanate from the center of the sensor. It is for an occupancy sensor plan. One circle diameter for hand movements and the other circle for body motion. Using the OOTB sensor (Lighting Device) gives me only two options Lighting Devices and <invisible lines> I want to create two different linetypes that I can control the diameter of each once placed. At the project level I can create new linetypes but the only subcategory is "Lines" This sounds like a question that has to have been asked before so if someone can point me to a thread or just say "No" you can't do that.
I have changes the category of the sensor and see that other subcategories are available but still have the same problem. thanks...
gary