Here is an interesting one. I have set the ini file.
[Graphics]
HiddenSlabEdge=Itself
But instead of hiding the line of intersection at the slab it hides the bearing line and shows the intersection line.
Has anyone else ran into this?
|
|
|
Here is an interesting one. I have set the ini file.
[Graphics]
HiddenSlabEdge=Itself
But instead of hiding the line of intersection at the slab it hides the bearing line and shows the intersection line.
Has anyone else ran into this?
Just checking if anyone knows anything about this problem. Since I first posted this question if seems that it doesn't matter what I set the .ini file to. Revit always shows all the lines associated with the thickened slab.
i create all thickened edges as model in place sweeps. this way i can use symbolic lines to graphically show design intent rather than every single piece of linework that just clutters up the drawings.