Hello,
I encounter problems of not being able to redefine an offset work plane in Inventor 2013.
The work planes are offset from the top face of a solid, which was created by one extrusion cutting another extrusion.
When I delete the extrusion making the cut, the work plane has the error "Coordinate system failure".
I try to redefine the offset work plane, and I get the prompt "Define work plane by highlighting and selecting geometry".
I try to select the "new" top face of the solid, and it highlights and turns blue, but that's all. It never completes the redefine.
If I hover over another parallel face, then it says "Click to create plane by two parallel planes".
What should I do?
Thanks