Good Morning,
A group at my office is making the switch from Microstation/inroads to Civil3D. This group handles Plat Reports / Plat Computations which I am really not very familiar with, as I have always given plats to our survey group. An example Plat Report was given to me (Hopefully) I can attach that here. And the question was asked "Can we generate this same information in Civil 3D"
I haven't attempted this before, but it seems that it really should not be a problem. We just need to set up all our Parcels and generate a report listing all the areas, then all the points with thier N/E, Bearings/Distances, Curve Data (Delta/Radius/Tangent/Arc/Chord/Bearing). Not sure where to start with this one, could someone point me in the right direction.
I am attaching the example Plat Report/Computation. I have blacked out the company logo and project information just to be on the safe side.
Thank you in advance for any help.
Patrick