Results 1 to 4 of 4

Thread: Custom Baluster Family

  1. #1
    Active Member
    Join Date
    2011-06
    Posts
    89
    Login to Give a bone
    0

    Angry Custom Baluster Family

    Is there a tutorial or .pdf or ANYTHING, that takes you through building a custom baluster family-start-post? I'm getting extremly frustrated because I have been trying to get a custom post to work paramtrically. I don't even know if I am leveraging the top and bottom cut angles properly. the bottom of the post sits 8" off the floor and even using the offset it goes nowhere. I try and get the two ends of the rail to meet, cause a railing is supposed to be continuous, but the Baluster end post is 3/4" below the stair rail and, once again, top offsetting does nothing.


  2. #2

  3. #3
    Member
    Join Date
    2012-02
    Location
    Vancouver
    Posts
    15
    Login to Give a bone
    0

    Default Re: Custom Baluster Family

    Does anybody know how to extend railing elements all the way to a custom baluster perpendicular to its stringer like the image attached, or if it is even possible? custom balusters.jpg If so, please send links! : )

  4. #4
    Member
    Join Date
    2012-02
    Location
    Vancouver
    Posts
    15
    Login to Give a bone
    0

    Default Re: Custom Baluster Family

    I found this tutorial too - https://www.youtube.com/watch?v=vsQBeAMAu04 - but am struggling to see how to apply the "top rail" and see if that works

Similar Threads

  1. What controls the direction of a custom baluster?
    By patricks in forum Revit Architecture - General
    Replies: 1
    Last Post: 2010-07-27, 05:06 PM
  2. Baluster, Baluster - Post and Baluster - Panel
    By phyllisr in forum Revit Architecture - Families
    Replies: 2
    Last Post: 2009-10-15, 03:27 PM
  3. Custom Baluster Height
    By courtlandtgross in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2009-08-18, 04:40 PM
  4. Custom Baluster Problem
    By ryan.87191 in forum Revit Architecture - General
    Replies: 5
    Last Post: 2006-06-19, 03:12 PM
  5. Save out a baluster family
    By J. Grouchy in forum Revit Architecture - General
    Replies: 7
    Last Post: 2005-03-30, 09:47 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •