Originally Posted by
tedg
Often times at our office, in cases like yours, each discipline would have thier own symbols, abbrevations and notes sheet in the set.
The general symbols are on the cover sheet such as elevation markers, section cut markers, room tags.
Using National Cad Standards as a convention (not knowing what you use)
an example would be sheet number T-001:
Telecommunications, General, sheet 01 in the sequence, and would contain such discipline-specific symbols, notes, abbreviations.
And if they ran out of room, they could have a T-002 and so on.
Then you would just need to make sure their symbols are following your company's cad standards, but not clutter up the cover sheet for all disciplines.
Just another thing to think about.