AutoCAD Printing Problems

[mattab222]

I am having problems printing straight to the printer from AutoCAD...the sheet seems to print like an inch or so on one side, but the rest (basically the entire sheet minus that 1" edge) is blank. I can print preview and everything looks fine. Everything is normal printing to PDF as well, so I don't know if this is an issue with the printer? I just don't like that extra step it takes to create the PDF then print from there...

[Tom Beauford]

Printing problems are so device, driver and setup specific you best bet is to see if someone else in your office can plot to the same printer with the same software.

[mattab222]

At first I thought it was a problem with the printer, but co-workers were able to print the same exact drawing from their computer with no problem...Maybe it's a graphics card issue with my PC.

[mattab222]

Yep...my coworkers are able to print the same exact drawing with no issue. I am assuming it is a problem with the graphics card in my PC, rather than a printer issue.

[Tom Beauford]

Graphics card would only affect display. Does the drawing have a Page setup name saved in the drawing all of you are using?