Hello, I am trying to create a CW Sliding Opened door but am experiencing some challenges when I actually try to "open" it.
When doing the extrusions constrained to the Template's RPs the family flexes fine. Adjusting itself to the CW Panel size.
But if I try to transpose it to the side, so that I can show the door opened, the new width does not seem to flex. But this happens only when loaded in the project. It works fine inside the Family Editor.
Please see attached file.
I kept a dummy door panel to test the "opened" version of it, while keeping the other panel inside the CW dimensions.
File attached.
Help appreciated.
Many thanks in advance.
J
DOR-CW Sliding2Pan_a.rfa