Steep Slope Analysis

[Iceberg]

Ok so this is my first attempt at creating a steep slope analysis.

So I basically have my existing TINN. I want to then show the areas of steep slopes. So I apply my Steep Slope Surface style, perform an analysis showing a range of 8 levels. Adjust my percentages and hit apply.

When I view my surface I got all of these areas that are not shaded in. They style is set to hatch, not to use 3dfaces.

slopes.PNG

Any ideas as to what I am doing wrong?

[Iceberg]

Okay. To follow up on this. I lose the shading when I update the percentage area for my slopes. Example, when adding the ranges you might get 0 to 4.235, 4.235 to 6.3332. When I go to reset them to something better like 0 to 2.5, and 2.5 and greater and apply those changes, that's when I lose the hatching.

[jpaulsen]

If you manually set the maximum slope for the highest range ID you will get areas that do not get shaded. You should leave the highest slope at the default value. The default on one of my surfaces is 32742.9583%.