Results 1 to 1 of 1

Thread: FITTING LOSS COEFFICIENTS - round elbow

  1. 2014-09-30, 09:03 AM #1
    uher.ondrej546355
    uher.ondrej546355 is offline
    Woo! Hoo! my 1st post
    Join Date
    2014-02
    Posts
    1
    Login to Give a bone
    0

    Default FITTING LOSS COEFFICIENTS - round elbow

    OK, I'm lost, mad and confused.
    As you could see from pictures below I have two identical round elbows. One is with angle 45.000° but second one is 45.001° or 44.995°. one has pressure loss coefficient but second one doesn't. It means that it couldn't set ashrae table to second elbow. Is it possible that it will make only 45° elbows? Yes I have it set in HVAC properties and I have angle units without decimal units.
    Could you please help me?
    Thank you
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 2013: 2013 Static Pressure loss Calculations Take-off Fitting errors
    By victoria.owens in forum Revit MEP - General
    Replies: 1
    Last Post: 2012-10-30, 08:39 PM
  2. Pipe elbow fitting to show straight not curve
    By EddieFromDc in forum Revit MEP - Families
    Replies: 0
    Last Post: 2012-01-20, 05:43 PM
  3. Round duct fittings loss coefficients
    By jevgeni704250 in forum Revit MEP - General
    Replies: 3
    Last Post: 2011-12-22, 10:52 PM
  4. 2012: how do loss coefficients work?
    By timsea81 in forum Revit MEP - General
    Replies: 0
    Last Post: 2011-09-27, 02:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules