what would be the best way to create an assembly for a levee?
|
How does your section look? Have you used Subassembly Composer?
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt
no experience with Subassembly Composer. it's a basic one, 10' wide top, with a 2:1 slope down to a certain elevation on one side and a 3:1 slope down to existing ground on the other.
i thought about using some Generic subassemblys, like link slope to elevation and link slope to surface with link offset and slope for the top, but wan't sure if that would be the best way.
Last edited by rmk; 2020-07-22 at 01:04 PM.
That should work. I've done similar using the generic subassemblies.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt