Summary: When using the PICK LINES tool to off set a riser in sketch mode, it should not always automatically use boundary as default. It should be the last one I used. (boundary or riser)

Description: I will be in sketch mode drawing a stair.
I want each tread to be 400 mm deep.

I draw one riser then hit PICK LINES and make an offset of 400mm
I specify the line to be a RISER LINE
I draw a few and hit escape either by accident or to draw something else then come back to the risers.
I want to continue adding risers I hit the PICK LINES tool again
IT DEFAULT IT MAKES ME CHANGE IT FROM BOUNDARY TO RISER AGAIN.

It should just still be set to riser.

Hope that's not too confusing.
Should be an easy fix.



Product and Feature: Revit Architecture - Stairs

Submitted By: pwmurdoch643401 on 10/30/2018