Casing (Trims) in cased openings dont show.

[Bluefairy]

I have cased openings that seem to appear correctly with the trims showing in my 3d views. However, when I go to my interior elevation view, the trims or casing does not show. I just see the opening. I checked my visibility graphics to see if the openings had been turn off but I dont see what needs to be turned on to have those trims show up in the interior elevation view. Any ideas?

[HermanS]

Hi Bluefairy, verify the detail level of your elevation view. It might be that the casing visibility in the family was set to only show at a fine level of detail.

[Bluefairy]

Right. I just discovered that the view detail level can be set to course, medium , or fine. If set to course, some objects like the casings dont show up.

[CAtDiva]

Also check the V/G in the family to see if the casing is set to show in all the detail levels and/or view directions.