Hello,
I have created a custom bend table for our shop, manually typing in the Bend Deduction for Each Radii/Thickness. Now on my drawings I want to automatically display that Bend Deduction that my table is pulling for the brake press operator.
Inventor is pulling the number from the table, so there must be a way to identify and display what it is pulling. I was going to create a user parameter and have it populate with that number, but I can't find where to pull that number.
I could write a iLogic rule say If this Thickness AND IF this Radii then make parameter = This BD, but I would be duplicating a LOT of work. There has got to be a way to just read that number.
Thanks
bend table.bmp