Results 1 to 2 of 2

Thread: Need a duct fitting that would split a rectangular duct in two ways

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2014-12
    Posts
    1
    Login to Give a bone
    0

    Question Need a duct fitting that would split a rectangular duct in two ways

    Hello,

    Which is the best duct fitting to use in the following scenario?




    If you have any family for this, please share it with me.

    Thanks in advance!

  2. #2
    Member
    Join Date
    2007-08
    Location
    Quad Cities, Illinois
    Posts
    44
    Login to Give a bone
    0

    Default Re: Need a duct fitting that would split a rectangular duct in two ways

    Rectangular Wye from Revit's default Out of the Box families

Similar Threads

  1. Round Duct tap into a Rectangular Duct
    By grojas in forum Revit MEP - General
    Replies: 4
    Last Post: 2014-12-22, 08:41 PM
  2. 2015: Revit MEP Duct Design WYE fitting volume split problem
    By razor_tr in forum Revit MEP - General
    Replies: 0
    Last Post: 2014-07-01, 08:53 AM
  3. 2013: Duct Fitting - Proportional Split
    By ReachAndre in forum Revit MEP - General
    Replies: 1
    Last Post: 2014-03-19, 01:56 PM
  4. 2012: Rectangular to Round Duct Fitting, CFM dissapearing
    By cyriousn in forum Revit MEP - General
    Replies: 4
    Last Post: 2014-01-27, 11:45 PM
  5. Rectangular Duct Fitting Transition...
    By cris8096 in forum Revit MEP - General
    Replies: 4
    Last Post: 2008-08-29, 08:22 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •