Overlapping duct and piping

[slovenc0417]

In the old days of AutoCad, when you you had duct or piping overlapping perpendicularly, you would break the line of the lower duct or pipe to clearly indicate which one was higher. And, honestly it makes the plan easier to read. Is there a way to do this in Revit?

Thanks!

[mhartmann]

set your view to Hidden Line, it will trim or dash the duct or pipe below. also make sure you're in a Floorplan view, a Reflected Ceiling view (looking up) in hidden will work the opposite way, it's very literal in what it sees.
hth,
mike

[slovenc0417]

Perfect... thanks!