room control point

[wpiotraschke691292]

Greetings. Is it possible to have the Room Control Point (RCP) be parametric once the family is placed into the model? For instance, I'm working on a signage family. For this particular sign I have set the RCP to a point on the opposite side on the wall to in order to reference that room. This works fine for 90% of my rooms. However, in some cases the room I would like to reference is either off to one side or the other, or even in front of the sign. Therefore, I would like to be able to adjust the location of the RCP once it is placed in the model.

Suggestions?

[HermanS]

Nope, natively the room calculation point is only movable in the family environment, not in the project environment.