Autoplant entities display only their boundary boxes

[bruno.vankogelenberg]

For this project we're using Autocad 2012, Autoplant V8I (SS4) 2012 and Navisworks 2015. Until we upgraded Navisworks from 2012 to 2015 everything worked fine.
Now half of the time I can open a DWG ( or an NWF) in Navisworks and everything displays as usual, but when I start working, i.e. open the DWG in Autocad, do something, save it and then refresh Navisworks to check, all Autoplant entties are only shown by their boundary boxes, similar to when a wrong object enabler is loaded. At this point, using the 2012 version from Navisworks works OK. After closing Autocad and refreshing Navisworks the Autoplant entities are displayed normally again.
Sometimes I get the problem on the initial opening in Navisworks, changing enabler from 2012 to 2011 or 2013 can fix the problem, sometimes changing the render type from shaded to rendered and back fixes the problem.

What am I missing here.

[dgorsman]

Are different users accessing the files?
Are they all set to the same DWG Reader version in Navisworks and have the correct AutoPLANT OE version installed?
Is everybody saving the same DWG version in AutoPLANT?

[bruno.vankogelenberg]

Hi, I have one colleage working on the same project. We both ude the same version of DWG reader, Autocad and Autoplant. I'm not quite shure what you mean by " the correct Autoplant OE version", but the version of Autoplant is the version we use since we installed Autocad 2012 (the latest version back then). Saving is done on format Autocad 2010.

[AutoTAD]

Curious if you found a solution to this thread.....I'm experiencing the same issue.

[AutoTAD]

Should have checked the Bentley website first....
Newer object enabler available.....version 08112111.
This fix worked for me.
-Tad

[zkshtmn708606]

Should have checked the Bentley website first....
Newer object enabler available.....version 08112111.
This fix worked for me.
-Tad

Hm, I cannot find it on Bently website, is says the last version is 08.11.09.140
could you share link here?