Is it possible to remove the "Flip" control on a fitting in MEP? I've built a very custom set of cable tray components using the content builder with accurate geometry, but fittings like a WYE have a distinct Left and Right configurations. Flipping a WYE literally makes it upside down and not usable like that!
The content is accurate to use for takeoff for prefab/ordering, I don't want my detailers to have the ability to flip a HYL to a HYR or vice versa, as the fitting counts would be incorrect on the schedule.
OR, if flipping is allowed, a way to recognize the fitting orientation, and to rename a property set accordingly.
The attached image is a combined screenshot of the fitting in MEP, and an overlay of the cut sheet image to immediately see why these can't be flipped over.