Transparent Cross Hatch Region lines covering Model Elements

[sam-archs]

Hi All,

I am having a problem with a cross hatch filled region, the region is transparent so I can see what's underneath. My problem is that the cross hatch lines are grey and the grey lines of the region runs over the model elements. I tried sending it to back but it doesn't help.

I attached a screen shot to show what I mean.

Thanks a lot for your help.

[tedg]

What's the purpose of the hatch?
Maybe you could create this on another level and use that level as an underlay?

[sam-archs]

The purpose is to show certain material @ that location. Modeling that part isn't needed, that's why I used a 2d hatch region.
when I replaced the hatch region by an actual 3d element, like a slab with a surface pattern, it worked, but I wanted to know if there is a way to have the hatch pattern of the filled region not overlap the model elements. In general it doens't make any sense that a 2d pattern overlaps model elements.

Thanks